服务热线 18660772233
0531-55536261
联系在线客服

山东微型电机厂家如何处理直流电机绕组短路?

来源:http://www.jnmcd.com 发布时间:2020-05-06 浏览:
  1.如果永磁直流电机的短路点在末端,则短路点可以用绝缘材料隔开,或者绝缘线可以重新缠绕、重新油漆、重新干燥。
  1. If the short-circuit point of permanent magnet DC motor is at the end, the short-circuit point can be separated by insulating material, or the insulating wire can be rewound, repainted and dried again.
  2.当短路在槽内时,可使导线软化,找到并修复短路点,然后将其放回槽内并涂干。
  2. When the short circuit is in the groove, it can soften the wire, find and repair the short circuit point, and then put it back into the groove and dry it.
山东微型电机
  3.当永磁直流电动机各相绕组的短路匝数小于1/12时,串联匝数的所有短路均可切断连接到导电部分,形成闭合回路紧急使用。
  3. When the number of short circuit turns of each phase winding of permanent magnet DC motor is less than 1 / 12, all short circuits of series turns can be cut off and connected to the conductive part, forming a closed circuit for emergency use.
  4.当绕组的短路点的匝数超过1/12时,应将所有绕组拆除并重新绕制。
  4. When the number of turns at the short-circuit point of the winding exceeds 1 / 12, all windings shall be removed and rewound.
  以上是山东微型电机厂家关于如何处理永磁直流电机绕组短路的介绍,希望大家对直流电机有更好的了解。
  The above is the introduction about how to deal with the winding short circuit of permanent magnet DC motor from Shandong micro motor manufacturer. I hope you have a better understanding of DC motor.
推荐新闻
  • 联系人:张经理
  • 手机:18660772233(微信同号)
  • 电 话:0531-55536261 / 0531-55536272
  • 邮 箱:911510021@qq.com
  • 地 址:山东济南市济南时代欧亚电子大厦一楼A111号
  • Copyright © 2018 济南美磁达电子有限公司 All Rights Reserved