服务热线 18660772233
0531-55536261
联系在线客服

微型电机厂家分享减速电机拆装时注意事项

来源:http://www.jnmcd.com 发布时间:2020-05-20 浏览:
  减速电机通常配有减速箱,可达到减速和增加扭矩的目的。在日常使用中,变速箱需要拆装。电动机齿轮箱拆装时应注意什么?
  The reduction motor is usually equipped with a reduction gearbox to reduce speed and increase torque. In daily use, the gearbox needs to be disassembled. What should be paid attention to when disassembling the motor gearbox?
  齿轮马达
  Gear motor
  1.电机减速箱底座安装牢固,在使用过程中,底座的振动幅度不得过大,产生噪声。保持排油箱内的油清洁,使电机内外通风顺畅,并在齿轮上安装保护装置。
山东微型电机
  1. The base of motor reducer shall be installed firmly. During the use, the vibration amplitude of the base shall not be too large to generate noise. Keep the oil in the oil drain tank clean, make the internal and external ventilation of the motor smooth, and install the protection device on the gear.
  2.检查电机减速箱内润滑油的量,检查零件的安装位置是否准确,各紧固件的压缩是否可靠,防止机壳可能造成的泄漏。
  2. Check the amount of lubricating oil in the motor gearbox, check whether the installation position of the parts is accurate, whether the compression of each fastener is reliable, and prevent the possible leakage caused by the casing.
  3.电机减速器安装时,应校正同心轴。误差不应过大,应在合理范围内。
  3. When the motor reducer is installed, the concentric shaft shall be corrected. The error should not be too large and should be within a reasonable range.
  4.安装减速机时不要使用重物或锤子。使用适当的工具来安装它。
  4. Do not use heavy objects or hammers when installing the reducer. Use the appropriate tools to install it.
  以上是山东微型电机为大家介绍的电动机齿轮箱拆装时应注意的事项。齿轮箱安装时,应保证齿轮箱的安装稳定性,安装人员应具备相应的技术,并进行多次试验。
  The above is the precautions for the disassembly and assembly of the motor gearbox introduced by Shandong micromotor. When installing the gearbox, the installation stability of the gearbox shall be ensured, and the installation personnel shall have corresponding technology and conduct multiple tests.
推荐新闻
  • 联系人:张经理
  • 手机:18660772233(微信同号)
  • 电 话:0531-55536261 / 0531-55536272
  • 邮 箱:911510021@qq.com
  • 地 址:山东济南市济南时代欧亚电子大厦一楼A111号
  • Copyright © 2018 济南美磁达电子有限公司 All Rights Reserved