服务热线 18660772233
0531-55536261
联系在线客服

定子线圈对于微型电机有怎样的作用?

来源:http://www.jnmcd.com 发布时间:2020-08-07 浏览:
机器的使用一段时间才回出现问题,如果注意保养检测的话就会避这些问题,比如高压电机的定子线圈腐蚀问题。定子线圈腐蚀对于电机的使用寿命和运行有着严重的影响。
It takes a long time for the machine to return to problems. If you pay attention to maintenance and inspection, you will avoid these problems, such as the stator coil corrosion of high-voltage motor. Stator coil corrosion has a serious impact on the service life and operation of the motor.
通过对多个电机故障现象的分析和运行试验得出,定子线圈的腐蚀分为内腐蚀和外腐蚀两种
Through the analysis and operation test of several motor faults, it is concluded that the corrosion of stator coil is divided into internal corrosion and external corrosion
造成这种现象的原因之一是槽部、端部的振动磨损和电晕腐蚀。由于线棒、槽部和端部的垫片松动、防晕处理不好,这样就造成槽楔、垫条和衬块松动、脱落断裂。使绝缘部分击穿。
One of the reasons for this phenomenon is the vibration wear and corona corrosion of the groove and end. Due to the looseness and poor anti corona treatment of the gaskets at the winding bar, slot and end, the slot wedge, gasket strip and lining block are loose, fall off and fracture. Make the insulation part breakdown.


我们可以通过以下的几种方法来处理这种问题:
We can deal with this problem in the following ways:
1、线圈和槽之间间隙过大,需要用漆或者树脂将空隙填满。
1. The gap between the coil and the slot is too large, which needs to be filled with paint or resin.
2、槽楔松动,可以调整槽楔的位置或者是在缝隙处加垫条。
2. If the slot wedge is loose, the position of the slot wedge can be adjusted or a cushion strip can be added at the gap.
3、如果是绕圈外形尺寸超标,需要根据图纸重新缠绕。
3. If the outer dimension of the winding exceeds the standard, it needs to be rewound according to the drawing.
4、如果是放晕漆失效,需要及时换 新的防晕
4. If the halo paint is invalid, it is necessary to replace it with a new one
本文由山东微型电机的小编为大家所介绍的,更多精彩内容请关注公司网站:http://www.jnmcd.com/。
This article is introduced by the editor of Shandong micromotor Co., Ltd http://www.jnmcd.com/ 。
推荐新闻
  • 联系人:张经理
  • 手机:18660772233(微信同号)
  • 电 话:0531-55536261 / 0531-55536272
  • 邮 箱:911510021@qq.com
  • 地 址:山东济南市济南时代欧亚电子大厦一楼A111号
  • 济南美磁达电子有限公司