来源：http://www.jnmcd.com 发布时间：2019-01-09 浏览：次
Notes for Gear Reduction Motor Device:
1. When installing the gear reducer motor, attention should be paid to the alignment of the transmission center axis. The error should not be greater than the compensation of the use of the coupling. Excellent alignment can prolong the service life and achieve the desired transmission power.
2. Hammers are not allowed to strike the transmission parts on the output shaft. In general, fixtures and internal threads at the end of the shaft are used to press the transmission parts in with bolts. Otherwise, the internal parts of the gear reducer motor may be damaged.
3. The gear reducer motor should be firmly installed on a stable level of foundation or base. The oil in the drainage tank should be removed and the cold air circulates. This is because in the process of operation, if the foundation is not reliable, it will cause vibration and noise, and promote bearing and gear damage. When the transmission connectors have outstanding features or select gears, sprocket transmission, should consider installing protective devices.
4. According to the rules of the device to ensure that operators can easily access the oil mark, ventilation plug, oil discharge plug. After the device is in place, the accuracy of the device is not specified, the reliability of each fastener is checked, and the device should be able to roll sensitively. Gear reducer motor uses oil pool to spatter smoothly. Before operation, the user takes off the screw plug of the ventilation hole and replaces it with the air plug.
Daily protection measures for gear reducer motors:
1. Gear reducer motor should always clean up oil and dust, keep clean, in order to facilitate heat dissipation;
2. Oil seal damage should be replaced in time.
3. The oil level should be checked frequently, and if the oil quantity is insufficient, it should be replenished immediately.
4. Smooth oil should be replaced regularly: when changing oil, power should be cut off to ensure safety. When looking at the oil, if it is found that the smooth oil is obviously turbid, please replace it as soon as possible.
5. Smooth oils of different quality should be noted that they can not be mixed.
6. The operation and protection of gear reducer motor shall be carried out in accordance with the operation instructions of the motor.
The above information is our Shandong micro-motor sorting and publishing hope to help you all on our website is: http://www.jnmcd.com!